Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
How Much Does Chimney Liner & Rebuild Cost in Bangor?
Our Chimney Liner & Rebuild services in Bangor, PA typically run between $900 and $6,500, depending on what the chimney actually needs. A standard stainless steel liner installation for a gas or oil appliance usually lands in the $900-$2,200 range, while a full chimney rebuild with new liner can reach $4,000-$6,500 or more for taller stacks or deteriorated crowns. Most Bangor homeowners we see pay somewhere in the middle – around $1,800-$3,200 for a liner replacement with minor masonry corrections.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here is how the numbers break down by job type, based on what we see in and around Bangor most often. These are real ranges from the Bangor market, not national averages pulled from a calculator somewhere.
| Service | Typical Price Range (Bangor, PA – 2026) | Notes |
|---|---|---|
| Stainless steel liner – gas/oil appliance | $900 – $2,200 | Single-wall or insulated; includes top and bottom termination |
| Stainless steel liner – wood-burning fireplace | $1,400 – $2,800 | Typically requires insulation wrap; UL-listed for solid fuel |
| HeatShield liner resurfacing (partial deterioration) | $1,200 – $2,400 | Applied by trained technicians; preserves existing tile |
| Cast-in-place liner system | $2,500 – $4,500 | Best for older Bangor fieldstone or rubble chimneys |
| Partial chimney rebuild (above roofline) | $1,500 – $3,500 | Spalling brick, failed mortar joints, damaged crown |
| Full chimney rebuild with liner | $4,000 – $6,500+ | Foundation-to-cap teardown and reset; older homes especially |
| Crown replacement or repair (add-on) | $250 – $750 | Often caught during liner install; done in same visit |
| Level-2 camera inspection (pre-liner) | $150 – $250 | Required before most liner jobs; credited toward repair in many cases |
What pushes the price up – and what keeps it down
Chimney height is the single biggest swing factor in Bangor. Many of the older homes in the borough and out toward the farmhouses on Route 512 were built with two-story chimneys serving multiple flues – some running 30 feet or taller. A 20-foot liner installation and a 35-foot liner installation are not the same job, and the material cost alone reflects that.
The condition of the existing flue tiles matters a great deal too. If the tiles are cracked but still structurally sound, HeatShield resurfacing can often do the job at a fraction of the cost of a full reline. If tiles are collapsed or the flue is offset in ways that block a rigid liner, you have fewer options and the price moves accordingly. Our Level-2 camera inspection – where we hand you the photos and walk you through what we found in plain English – is what tells us which scenario you’re actually in. Guessing costs you money either way.
Liner diameter is also a real variable. Older Bangor homes with coal-converted furnaces were often vented through oversized flues. Downsizing to match a modern high-efficiency boiler requires the right liner size per BTU rating, and that calculation matters for both safety and efficiency. Getting it wrong creates draft problems or, worse, carbon monoxide concerns – so we size every liner to the appliance, not to what’s easiest to carry up a ladder.
What Affects Chimney Liner & Rebuild Pricing in Bangor
- Chimney height and number of flues: Taller chimneys require more liner material, more labor hours on the roof, and in some cases staging equipment. Two-flue chimneys serving both a fireplace and a furnace each need their own liner run.
- Liner type and material: A single-wall stainless liner for a gas appliance costs less than an insulated rigid liner for a wood stove. DuraFlex flexible liner systems cost slightly more than rigid stainless but navigate offset flues without major masonry work, which can actually save money overall.
- Flue tile condition: Hairline cracks that haven’t compromised structure allow for HeatShield resurfacing. Buckled or collapsed tiles push the job toward full relining. A collapsed section changes everything.
- Local weather wear: Bangor sits in a zone that sees hard freeze-thaw cycles every winter. The slate ridgeline and the Lehigh Valley basin create conditions where mortar and tile joints degrade faster than they might in a more sheltered climate. We regularly find spalling damage in Pen Argyl and Bangor homes that dates back multiple winters but went unnoticed until a Level-2 inspection caught it.
- Permit requirements: Most liner replacements in Northampton County don’t require a separate building permit, but a full tear-down rebuild typically does. We handle that process and factor the filing time into the schedule – it’s not an afterthought.
- Access and roof pitch: Steep-pitch roofs, tight soffits, or a chimney positioned awkwardly near a dormer all add staging time. This is an honest cost – we don’t hide it in a low estimate and adjust it later.
How to Save on Chimney Liner & Rebuild
The single most useful thing you can do before committing to any liner or rebuild work is get a proper Level-2 camera inspection done first. That’s not something we say to generate inspection revenue – it’s because we’ve seen plenty of Bangor homeowners who were quoted a full reline when a HeatShield application would have done the job, and vice versa. The inspection tells you which is which. When you know what you’re actually dealing with, you can make a decision on the actual problem rather than someone’s educated guess.
If you’ve already received a written estimate from another company, take us up on our Free Second Opinion. We’ll look at what they found, run our own inspection, and tell you plainly whether we agree. No pressure, no obligation. If their diagnosis is right and their price is fair, we’ll tell you that too.
For homeowners 62 and older or any U.S. veteran, our permanent 5% Senior and Veteran discount applies to the full job – liner, masonry, and all. That’s not a coupon with an expiration date. It’s just a standard reduction because those customers have earned it.
If your repair comes in over $250 – which most liner jobs do – the $50 Off Any Repair Over $250 offer brings that number down a bit further. And our $89 Seasonal Tune-Up is worth doing before a liner job is quoted, because sometimes what looks like a liner problem from outside turns out to be a damper or cap issue that’s a fraction of the cost.
Timing can matter. Late summer and early fall are our busiest weeks in Bangor and throughout the Slate Belt, because everyone calls at once when they light the first fire of the season and something smells off. Scheduling your inspection and any planned work in June or July often means faster turnaround and sometimes greater technician availability. We don’t discount for timing – but you’re more likely to get your first-choice appointment.
Finally: do the liner job once, with the right materials. A builder-grade liner that fails in five years isn’t savings – it’s a second liner job plus the cost of the first one. We use DuraFlex and Olympia Chimney liner systems because they hold up. That’s not a brand pitch. It’s the reason we can back the work with our 90-Day Done Right Promise in writing.
Call (610) 609-7634 to schedule a free estimate. A live person will answer – not a voicemail, not an app.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner replacement cost in Bangor, PA?
A chimney liner replacement in Bangor typically costs $900 to $2,800 for stainless steel liner systems, depending on fuel type, chimney height, and whether the flue needs insulation wrap. Gas and oil appliances sit toward the lower end; wood-burning fireplaces and stoves run higher because they require heavier-gauge, UL-listed solid-fuel liner material. If you’re in Bangor Borough or the surrounding Pen Argyl area and the chimney is more than 25 feet tall, plan for the higher end of that range. Call (610) 609-7634 for a free estimate – we’ll measure and quote without charge.
Is it cheaper to reline a chimney or rebuild it?
Relining is almost always less expensive than a rebuild. A stainless liner install or HeatShield resurfacing in Bangor runs $900 to $2,800, while a partial or full rebuild adds $1,500 to $6,500 or more to that figure. The real question is what the chimney actually needs – if the masonry structure is compromised, no liner solves that underlying problem. Our Level-2 camera inspection gives you a documented answer rather than a guess. Spending $150 to $250 on a proper inspection before committing to either path almost always saves money. For more detail on what’s involved in each approach, visit our Chimney Liner & Rebuild in Bangor service page.
How long does a chimney liner last in Pennsylvania’s climate?
A properly installed stainless steel liner – particularly an Olympia Chimney or DuraFlex system – should last 20 to 30 years or longer under normal use in Pennsylvania’s climate. What shortens that lifespan is freeze-thaw cycling that was already weakening the surrounding masonry, improper sizing for the appliance, or using a builder-grade liner that wasn’t rated for the application. HeatShield ceramic resurfacing has a comparable service life when applied correctly. The Bangor area’s winters are hard on chimneys – getting the material right matters more here than it might in a milder market.
Do I need a permit for chimney liner replacement in Bangor, PA?
For most liner replacements in Bangor – swapping an old liner or installing a stainless system inside an existing flue – a separate building permit is generally not required by Northampton County. A full chimney rebuild that involves structural masonry work typically does require a permit, and we handle that filing process as part of the job. Requirements can vary depending on local municipality rules, so we confirm the permit status before any rebuild begins. You won’t get surprised by a stop-work notice on a job we’re managing.
Can Hearthstone Chimney Co. complete a liner job in one visit?
Most liner installations in Bangor – including the full run of a stainless or flexible liner with top and bottom terminations – are completed in a single visit. Larger jobs involving partial or full masonry rebuilds may require a second day, particularly when mortar cure time is involved. We tell you the schedule upfront, before the job starts. Russell Haines and the Hearthstone crew have been scheduling and completing chimney work in this area since 1984, so we’ve gotten reasonably good at knowing how long a job actually takes. Call (610) 609-7634 and we’ll give you a straight answer on timeline for your specific chimney.
What is the 90-Day Done Right Promise?
It means exactly what it says: if the work isn’t right within 90 days of completion, we come back and make it right. No paperwork to fill out, no arguments, no service fee to get us back out. It’s in writing on every estimate we issue, and it applies to liner work, masonry repairs, and any other service we perform. Russell Haines built Hearthstone Chimney Co. on the idea that a company still planning to be in Bangor thirty years from now has to stand behind its work – so that’s what we do. Our full-service overview is on the home page if you’d like to read more about how we work.
Key Takeaways
- Chimney liner replacement in Bangor, PA costs $900 to $2,800 for most standard stainless liner jobs; full rebuilds with a liner run $4,000 to $6,500 or more.
- Chimney height, flue tile condition, liner material, and Bangor’s freeze-thaw climate are the four biggest price variables.
- A Level-2 camera inspection ($150-$250) before committing to any liner work is the most reliable way to avoid paying for the wrong solution.
- HeatShield resurfacing can extend the life of a cracked-but-sound flue at a lower cost than full relining – but only if the structure warrants it.
- Hearthstone backs every job with the 90-Day Done Right Promise, in writing, and has served this area since 1984.
- Senior and Veteran customers receive a permanent 5% discount; any repair over $250 qualifies for $50 off.
- A live person answers at (610) 609-7634, around the clock, every day of the year.
Ready to Get an Accurate Number for Your Chimney?
Every chimney in Bangor is a little different – the age of the home, the height of the stack, what’s been done to it before, and what it’s venting all factor into a real estimate. The only way to give you a number that means something is to look at it, document what we find with photos, and explain what we’re seeing in plain English. That’s what we do, and the estimate itself costs nothing.
Russell Haines and the Hearthstone Chimney Co. crew have been doing this work in and around Bangor since 1984. We use professional-grade liner systems from DuraFlex, Olympia Chimney, HeatShield, and Famco. We back every job with the 90-Day Done Right Promise, in writing. And when you call, a real person answers.
Call (610) 609-7634 to schedule your free chimney liner estimate. We’re here.
Pricing reflects the Bangor market as of 2026. Hearthstone Chimney Co. offers free estimates – call (610) 609-7634.
Written by Russell Haines, Owner at Hearthstone Chimney Co., serving Bangor, PA since 1984.
What Our Customers Say
"Creosote buildup was worse than I realized. He measured it, put a camera up to show me the glazing on the flue, and was honest that we were closer to a chimney fire than I wanted to hear."
- Mark Bennett"The fireplace had never drawn properly since we moved in. He found the damper was only opening halfway on a bent linkage and fixed it in ten minutes."
- Tim Kowalski"The cap keeps the birds out now, which after two springs of scratching noises above the bedroom is worth every penny."
- Nisha Gupta





Before
After
Before
After
Before
After